window dressing Archives - Page 2 of 4

Build It, Contributor, Decorating, DIY, Home Decor, shutters, window dressing

DIY Interior Cedar Shutters

Hello Pretty Handy friends, Jaime from That’s My Letter here today to share how to build functional interior cedar shutters using inexpensive AND readily available hardware.

I have been itching to build some cedar shutters for our living room for quite some time now. I had two requirements: 1) they had to be completely functional to block out the hot summer sun (which also makes them great for privacy) and 2) use no fancy hardware. I didn’t want to special order any shutter hardware and I like to build using readily available supplies.

You can find the cedar planks and hardware at your local home improvement store. Ready to learn how to build the shutters and install these beauties?

You can see just how much light the shutters will block out once closed. I plan to keep the shutters open except during the extremely hot summer days.

Interior cedar shutters make a great alternative window treatment if you’re not into fabric panels. They truly are a statement piece (and hopefully distract from the fact that my windows don’t match!). I also built the sliding door console last Spring, a link to all the details on that piece is in this post.

Materials:

cedar boards (1×6 and 1×4)
saw
nail gun
1 1/4″ finish nails
1×2 pine board
2″ wood screws
drill & bits
pencil
measuring tape
wood putty
sandpaper
paint
hinges (pictured below) & screws

Hardware: (for one pair of shutters)

2 – 2 1/2″ hinge (spray painted oil rubbed bronze) & 12 screws
2 – 4″ decorative tee hinge & 12 screws

Instructions:

MEASURE YOUR INTERIOR WINDOW SPACE. MEASURE IT AGAIN. MEASURE IT AGAIN. The top of the window may vary from the bottom. Read more

September 17, 2014/12 Comments/by Jaime Costiglio

accessories, bedroom, curtains, decor, Decorating, Master Bedroom, window dressing

Easy and Inexpensive Romantic Curtains

Are your windows naked? What’s holding you back? Don’t have the funds to buy some? Don’t have the time to sew some? I have the instant cure for your naked windows. Get ready to make your own easy and inexpensive romantic curtains! Best of all, you don’t have to sew a thing!

Materials:

2 Flat twin sheets from Walmart ($4.97 ea.)
10 Curtain ring clips

Instructions:

Fold your bed sheet in half lengthwise at the top edge. Pleat the left corner and clip a ring over the pleats approximately 2-3 inches below the top edge.

Pleat and add another clip at the fold. Gather another pleat halfway between your two clips and add a third clip. Read more

August 29, 2014/10 Comments/by Brittany Bailey

adfree, DIY, Door, Door Hardware, Fix It, Home & Auto Maintenance, Home Safety, Tutorial, Window, window dressing

Install Security Film to a Glass Door and Protect Your Home

How to Add Security Film to Glass Doors & Windows | Pretty Handy Girl

The folks at Allstate Insurance have graciously sponsored this post, which will help you learn how to install security film to safeguard your doors (or windows) from a potential break-in! It’s a simply DIY solution that could potentially save you the heartache of having your home burglarized.

I’ve noticed an unsettling trend in our area. There are more thefts popping up around our neighborhood. Luckily the majority of them are burglaries with no violence. But, it’s still unsettling. If you want the latest on crimes around you, sign up for SpotCrime.com. Simply enter your address and you’ll get emails when crimes are reported around you. Then again, this could lead to a bit of paranoia {raising hand.}

Regardless, there are two doors in our home that have always caused me some concern. We have two half window doors that needed some added security measures. The first one is the entrance to our mudroom. The second one is the back door to our garage (and you know I’d be heartbroken if anyone stole my power tools!)

If you have a door like this, a burglar can simply break the pane of glass closest to the knob, reach in and turn the deadbolt and handle. One option is to install a two-sided keyed entry deadbolt lock. Because we have little children, I worried about them not being able to find the key and get out of the house in the event of a fire.

This past week I happened to hear about security film and did a little research. I was skeptical until I tested the material myself. The results seriously amazed me! You can watch my test in the video later in this post.

In the meantime, here are the supplies you’ll need and the very simply installation instructions!

(I’ve included affiliate links for your convenience. I earn a small percentage from a purchase using these links. There is no additional cost to you. You can read more about affiliate links here.)

Materials:

8 Mil Security Window Film
Spray bottle with water and a few drops of dish soap (or baby shampoo)
4 inch Squeegee
Paper towels
Razor blade
X-acto knife (or scissors)
Metal Ruler
Ball point pen or fine-tipped sharpie
Cutting surface

Instructions:

1. Begin by removing the grill if you have one solid piece of glass with faux dividers (see my video below for more details on removing the grill.) If you have true divided light, move on to the next step.

2. Measure your windows. Reduce the size by 1/8″ to leave space at the edges for the water to escape. Transfer the measurements onto the film with pen. Cut the window film with the x-acto knife and ruler. (You could use scissors in a pinch.)

How to Install Window Blinds and Curtains {Lowe’s Creator}

Painted Lampshade & a Quick Guest Room Makeover | Pretty Handy Girl

Whoa. What happened to summer? Labor Day is here and that means the holidays are just around the corner. I’ve started to think about sprucing up our guest room in anticipation of having guests. The number one complaint our guests have (not that many of them complain) is that there is too much light that comes in the window in the morning. When Lowe’s asked us to focus on window treatments in September, I realized the time had come to address this blinding light situation. Little did I know, that installing new blinds and curtains would take less than an hour!

Here is the basic window that I started with. (Yes, there’s a roller shade there, but it was hidden under a valance and frankly it’s a pain to use.)

After taking a few measurements, I headed to Lowe’s to look at the options for window blinds and curtains. It was a tough decision because I really liked some of the roman shades. But, I wanted a blind that wouldn’t block much light when it was raised. I settled on the Levolor cordless room darkening cellullar shade. Not only does it have a low profile when installed, but raising it and lowering is as easy as pressing a button. Plus, no strangulation hazards because there are no external cords! I’m kicking myself for not doing this sooner.

How to Install Blinds and Curtains from Lowe’s in less than an hour: Read more

September 2, 2013/11 Comments/by Brittany Bailey